« previous next »
Pages: 1 [2]   Go Down

Author Topic: Plastisol on top of dc base question  (Read 3403 times)

Offline blue moon

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 6366
Re: Plastisol on top of dc base question
« Reply #15 on: July 23, 2013, 08:38:11 AM »
Quote from: ebscreen on July 22, 2013, 03:50:36 PM
Quote from: blue moon on July 22, 2013, 03:13:19 PM

-we have one head that's out about 5-6/1000th of an inch. If we don't add a little bit of trap, white will show every now and then. (yes, the infamous registration block MHM issue!)


If it was the blocks you would have issues with a certain pallet(s) rather than a certain head. And it would almost never be just one.

I meant platen, thanx for catching that. there are two more that are out 2-3/1000th of an inch, but that is really not visible on most prints.

pierre
Logged
Yes, we've won our share of awards, and yes, I've tested stuff and read the scientific papers, but ultimately take everything I say with more than just a grain of salt! So if you are looking for trouble, just do as I say or even better, do something I said years ago!

Offline ebscreen

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4278
Re: Plastisol on top of dc base question
« Reply #16 on: July 23, 2013, 12:32:26 PM »
Got it, just wanted to make sure you weren't chasing ghosts.
Logged

Offline chubsetc

  • Full Member
  • ***
  • Posts: 228
Re: Plastisol on top of dc base question
« Reply #17 on: July 23, 2013, 05:39:40 PM »
Are you guys running your shirts with the dc base through the dryer the same speed as straight discharge or are you speeding it up a bit, running my discharge at 360 degrees for 2 minutes currently.
Logged

Offline blue moon

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 6366
Re: Plastisol on top of dc base question
« Reply #18 on: July 23, 2013, 05:48:27 PM »
Quote from: chubsetc on July 23, 2013, 05:39:40 PM
Are you guys running your shirts with the dc base through the dryer the same speed as straight discharge or are you speeding it up a bit, running my discharge at 360 degrees for 2 minutes currently.

we are slowing down the belt, but keeping the temp the same.

pierre
Logged
Yes, we've won our share of awards, and yes, I've tested stuff and read the scientific papers, but ultimately take everything I say with more than just a grain of salt! So if you are looking for trouble, just do as I say or even better, do something I said years ago!
Pages: 1 [2]   Go Up
« previous next »