gauntlet zbar

[ericheartsu]

I need to get a zbar for our gauntlet so that i can register the press. Anyone know what type of zbar we need? I called M&R parts, who then sent me to support, who then sent me back to parts, who then put me on hold for 30 minutes, then i hung up.

any help would be much appreciated!

[Homer]

can borrow mine if you want. or I can get you the dimensions.

20"long x 9" tall" x 12" long..like my drawing? 1/2" hole on the 20" end.


-------------------------.
                                .
                                .
                                  ---------------------

[ericheartsu]

can borrow mine if you want. or I can get you the dimensions.

20"long x 9" tall" x 12" long..like my drawing? 1/2" hole on the 20" end.


-------------------------.
                                .
                                .
                                  ---------------------

ha! thanks for the offer, and that is a really good cad drawing

[dirkdiggler]

my old shop threw 2 of those in the dumpster.  sure mr. hoffman will be on this post soon.

[244]

my old shop threw 2 of those in the dumpster.  sure mr. hoffman will be on this post soon.

Our parts manager is trying to contact him now to find out what the delay was. All of our calls to parts and service are recorded but take a few minutes to pull down.

[dirkdiggler]

What did I tell ya?  Thats why M&R can NOT be beat.  btw, matt got those squeegee clamps installed and I can say goodbye to the sliding squeegee, thanks Rich.