« previous next »
Pages: [1]   Go Down

Author Topic: M&R Side Conversion Kit for Chameleon  (Read 866 times)

Offline Ross_S

  • Sr. Member
  • ****
  • Posts: 349
M&R Side Conversion Kit for Chameleon
« on: December 30, 2019, 07:55:09 PM »
Has anyone ever converted a rear clamp manual to side clamp?  I just got my kit in to do so but they have no diagrams or instructions for it.  I'm looking for help on this or really just a close up picture so I can make sure I'm doing it correctly.  M&R has no documentation on this.

I don't think it is going to be difficult but I really just need a good picture to go off of.  Any help would be appreciated thanks

Ross
Logged

Offline gotshirtz001

  • Full Member
  • ***
  • Posts: 139
Re: M&R Side Conversion Kit for Chameleon
« Reply #1 on: December 31, 2019, 10:57:22 PM »


This should give you a couple angles. The cross bar uses the top bolt holes on the head face. The bottom holes are unused. 


Sent from my iPhone using Tapatalk
Logged
I'm flexible until I'm not

Offline gotshirtz001

  • Full Member
  • ***
  • Posts: 139
Re: M&R Side Conversion Kit for Chameleon
« Reply #2 on: December 31, 2019, 10:58:48 PM »


Here’s another I packed up to sell


Sent from my iPhone using Tapatalk
Logged
I'm flexible until I'm not

Offline gotshirtz001

  • Full Member
  • ***
  • Posts: 139
Re: M&R Side Conversion Kit for Chameleon
« Reply #3 on: December 31, 2019, 11:02:55 PM »


From the manual


Sent from my iPhone using Tapatalk
Logged
I'm flexible until I'm not

Offline Ross_S

  • Sr. Member
  • ****
  • Posts: 349
Re: M&R Side Conversion Kit for Chameleon
« Reply #4 on: January 01, 2020, 07:38:30 AM »
Those are good pics; thank you. 
Logged
Pages: [1]   Go Up
« previous next »