« previous next »
Pages: [1]   Go Down

Author Topic: False thread breaks??  (Read 1066 times)

Offline whitewater

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1830
False thread breaks??
« on: September 21, 2018, 09:11:38 AM »
What could be the main culprit? I have played around with tensions and bobbin casing... It happens on different thread colors, so am I correct in assuming its the robin casing, with the little screw?
Logged

Offline mk162

  • Ludicrous Speed Member
  • *******
  • Posts: 7862
Re: False thread breaks??
« Reply #1 on: September 21, 2018, 10:07:26 AM »
Swap in a new bobbin case with the correct tension.

We use magna-glides and remove the bobbin case springs.  It leaves less junk in the hook arm since there is no paper on the bobbins.  Blow out the gunk in and around the rotary hook.
Logged

Offline mooseman

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2215
Re: False thread breaks??
« Reply #2 on: September 21, 2018, 10:28:57 PM »
What do you mean by false breaks?
Does it happen on the same needle?
Are you familiar with the threadbreak photo sensors on every needle??????
Mooseman
Logged
DUE TO CIRCUMSTANCES COMPLETELY WITHIN MY CONTROL YOU SHOULD GET YOUR OWN TEE SHIRT AND A SHARPIE MARKER BY NOON TOMORROW OR SIMPLY CALL SOMEONE WHO GIVES A SHIRT.

Offline 1964GN

  • Hero Member
  • *****
  • Posts: 833
Re: False thread breaks??
« Reply #3 on: September 22, 2018, 07:57:15 AM »
We once had an issue where the cable to the thread sensor board was a tad short and was pulling apart over time, so if the above doesn't solve the issue you may want to investigate a possible cable issue.
Logged
Pages: [1]   Go Up
« previous next »