Author Topic: Plasticharge base with Plastisol top colors  (Read 1590 times)

Offline Sbrem

  • Ludicrous Speed Member
  • *******
  • Posts: 6055
Plasticharge base with Plastisol top colors
« on: August 02, 2018, 08:59:56 AM »
 A while back I posted a problem we had with the top plastisol colors not sticking and coming out in the wash. The answer was "too much white pigment" in the Plasticharge. I've tried searching for the thread, but after 15 minutes, it's time to ask for help. What is the correct amount of the Maxopaque Mixing White to the Plasticharge base? I know it's less than the normal 50/50 mix. Thanks in advance guys...

Steve
I made a mistake once; I thought I was wrong about something; I wasn't


Offline mk162

  • Ludicrous Speed Member
  • *******
  • Posts: 7862
Re: Plasticharge base with Plastisol top colors
« Reply #1 on: August 02, 2018, 09:03:55 AM »
My understanding it is 20% white, 80% base.

That being said I screwed up one time and did 50/50.  We ended up heat pressing them after they were run through the dryer and it worked.  The prints were still really bright and they didn't come off.

We wasted a lot of time heat pressing, but it was better than reordering 400 tanks and reprinting them.

Offline Sbrem

  • Ludicrous Speed Member
  • *******
  • Posts: 6055
Re: Plasticharge base with Plastisol top colors
« Reply #2 on: August 02, 2018, 09:51:53 AM »
Thanks, we appreciate it. We don't need to have the colors wash off of a job that's late already...

Steve
I made a mistake once; I thought I was wrong about something; I wasn't