Author Topic: Making black out of odds and ends.  (Read 1523 times)

Offline Frog

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 13980
  • Docendo discimus
Making black out of odds and ends.
« on: June 08, 2018, 01:39:13 PM »
Plastisol
So, do any of you recycle your mis-mixes or leftovers into black?
Do you use a little of the crap along with a bunch of real black, or do you use pigments? Both?
That rug really tied the room together, did it not?


Offline tonypep

  • Ludicrous Speed Member
  • *******
  • Posts: 5683
Re: Making black out of odds and ends.
« Reply #1 on: June 08, 2018, 01:47:43 PM »
I believe Rutland/Wilflex have a product specifically for this

Offline brandon

  • Gonzo Member
  • ******
  • Posts: 1709
Re: Making black out of odds and ends.
« Reply #2 on: June 08, 2018, 10:19:24 PM »
If I remember correctly it is a thick black concentrate paste. It works. But I would only use it on "car wash" shirts. Meaning the giveaway local charity run or whatnot. But advertise it as recycled ink with a discount for the client.

Offline Colin

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1610
  • Ink and Chemical Product Manager
Re: Making black out of odds and ends.
« Reply #3 on: June 08, 2018, 10:52:04 PM »
Frog:  Are you asking if anyone actually does this and their experiences with it?

I did at one point in time try it out - but weeding out all the mixes that had white pigment in them was a pain/time consuming.  Worth it for huge jobs, or if you have lots of down time to play.

You also want to pay attention to how much color is going into the mix - depending on just how "black" you want the ink to look. 

Some are fine and dandy with it being an "inky" black - others want a total lack of color "black".

Either way, I have always recommended adding junk ink of choice 25%-40% to a finished black - or into an in house mix of black ink with a 10% black pigment load to cover up the colors being added.

I would then add ink modifiers to create the print qualities you want.

I have talked about a first down chromatic black I made for a job involving multiple flashes.  I used about about 2% black pigment into my chromatic mix of (8% ish) red/green/blue... juuuust enough to look closer to black but not go up in smoke under the quartz flashes.

Hope this answered your question :)
Been in the industry since 1996.  5+ years with QCM Inks.  Been a part of shops of all sizes and abilities both as a printer and as an Artist/separator.  I am now the Ink and Chemical Product Manager at Ryonet.

Offline Frog

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 13980
  • Docendo discimus
Re: Making black out of odds and ends.
« Reply #4 on: June 09, 2018, 12:03:25 AM »
Yep Colin, I was wondering of this is common. I do it, about 1/3 of my usual dark maroonish gray that accumulates over time to 2/3 Ultrasoft black, and then put a little softhand whack on it as needed.
Back when the PC system was new, I inherited a set of pigments, but never replaced them, but it seems thast a little bit of PC black would provide a little insurance in getting a real black.

While on the subject of the maroonish gray I seem to accumulate, I also use it for tone on tone based down like crazy.
That rug really tied the room together, did it not?