Above Pocket Tips?

[1964GN]

We'll, the first job is above the pocket :/

I am looking for tips and/or tricks for hooping. These are Port Authority button downs and will get embroidered over both left and right pockets. One is an American Flag about 4"w and the other is a logo (Custom lettering) about 4.5" wide. The pockets are a hair under 5" wide. Any tips for getting the bottom of each design the correct distance from the pocket?

[jvanick]

We'll, the first job is above the pocket :/

I am looking for tips and/or tricks for hooping. These are Port Authority button downs and will get embroidered over both left and right pockets. One is an American Flag about 4"w and the other is a logo (Custom lettering) about 4.5" wide. The pockets are a hair under 5" wide. Any tips for getting the bottom of each design the correct distance from the pocket?

Lasers.  we have a 4 'line' system from Binkspot that works awesome for this.

[tonyt79]

Lasers are the way to go. I have rigged stuff up that work, but if you can get a laser system that will help and a lot faster!

Sent from my SM-N915T using Tapatalk

[mooseman]

real easy...print your logo on a folder or similar card stock, cut the cardstock below the design at 1/2 or 3/4 inch and as wide as the pocket.
set the design over the pocket center it and mark the center of the logo with a spot of chalk.
get a thin rubber band and criss cross it on your hoop such that it crosses at  the  center of the hoop. Hoop your shirt with the intersection of the crossed band over the center mark of your logo mark.
lastly take a straight edge and lay it across your hoop parallel with some reference like the hoop edge, the hoop screws or other geography then  eyeball the edger to the pocket line...get them parallel by eye then sew away.
Once you have the cardboard template cut and marked it is lightning fast to get the logo dead nuts.
If this is all too confusing I can post some pics.
mooseman

[1964GN]

real easy...print your logo on a folder or similar card stock, cut the cardstock below the design at 1/2 or 3/4 inch and as wide as the pocket.
set the design over the pocket center it and mark the center of the logo with a spot of chalk.
get a thin rubber band and criss cross it on your hoop such that it crosses at  the  center of the hoop. Hoop your shirt with the intersection of the crossed band over the center mark of your logo mark.
lastly take a straight edge and lay it across your hoop parallel with some reference like the hoop edge, the hoop screws or other geography then  eyeball the edger to the pocket line...get them parallel by eye then sew away.
Once you have the cardboard template cut and marked it is lightning fast to get the logo dead nuts.
If this is all too confusing I can post some pics.
mooseman

Awesome post. Thank you!

[tonyt79]

Holy cow, sorry I missed the embroidery part! Was thinking screening them.

Sent from my SM-N915T using Tapatalk