Author Topic: The ins and outs of successful discharge printing  (Read 2641 times)

Offline mimosatexas

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4221
  • contributor
Re: The ins and outs of successful discharge printing
« Reply #15 on: September 02, 2014, 12:28:12 PM »
add water/penetrant and stroke multiple times.


Offline jvanick

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2477
Re: The ins and outs of successful discharge printing
« Reply #16 on: September 02, 2014, 12:32:04 PM »
I normally use 5% penetrant.. should I mix more in?

Offline mimosatexas

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4221
  • contributor
Re: The ins and outs of successful discharge printing
« Reply #17 on: September 02, 2014, 12:35:29 PM »
that should be plenty.  Try adding a bit of water as well, maybe another 5%.  Depends on your base, humidity, how long the run is, etc.  White will require more water than something like a yellow.

Offline TCT

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2877
Re: The ins and outs of successful discharge printing
« Reply #18 on: September 02, 2014, 10:41:22 PM »
Scott: any special notes to get it to go all the way through easier/better?
Pretty sure Rutland makes a additive that helps pull the technique off.
Alex

Hopefully I'll never have to grow up and get a real job...

www.twincitytees.com