lasers just arrived....

[hoogie]

Blinkspot(Brian) what a great dude to work with...shipped em fast, looked just like the picture he posted on the forum...turned those suckers on and man finished a job on zippered hoods for Hard Rock on smalls that gave me less than a quarter inch top to bottom to space this design or less with no scrap...I coulda got it done without but i'll give brian credit...these things are built top notch...thanks to these forums and others reply about his lasers...without it I would of went a more expensive route...and hardly do people take the time to offer thanks on a job well done...most the time ya never hear from them again unless something is wrong...well not this time...thanks again Brian if I need another set i'll call ya!

[Binkspot]

Thanks, glad they worked for you.

[GKitson]

Blinkspot(Brian) what a great dude to work with...shipped em fast, looked just like the picture he posted on the forum...turned those suckers on and man finished a job on zippered hoods for Hard Rock on smalls that gave me less than a quarter inch top to bottom to space this design or less with no scrap...I coulda got it done without but i'll give brian credit...these things are built top notch...thanks to these forums and others reply about his lasers...without it I would of went a more expensive route...and hardly do people take the time to offer thanks on a job well done...most the time ya never hear from them again unless something is wrong...well not this time...thanks again Brian if I need another set i'll call ya!

Laser Tip - Use your laser when changing platens to insure all are placed/replaced accurately.  Simply target the first (master) platen at the outside edge then remove and replace all the rest using that target location.  Never look for a tape measure for that purpose again.

[hoogie]

Blinkspot(Brian) what a great dude to work with...shipped em fast, looked just like the picture he posted on the forum...turned those suckers on and man finished a job on zippered hoods for Hard Rock on smalls that gave me less than a quarter inch top to bottom to space this design or less with no scrap...I coulda got it done without but i'll give brian credit...these things are built top notch...thanks to these forums and others reply about his lasers...without it I would of went a more expensive route...and hardly do people take the time to offer thanks on a job well done...most the time ya never hear from them again unless something is wrong...well not this time...thanks again Brian if I need another set i'll call ya!

Laser Tip - Use your laser when changing platens to insure all are placed/replaced accurately.  Simply target the first (master) platen at the outside edge then remove and replace all the rest using that target location.  Never look for a tape measure for that purpose again.

thanks greg, good tip for some...happens I have a '14 12/10 in here that has the platen adj. arm on it to make sure there all spot on when change overs happen...But I'm sure that we'll use those things for a heck of a lot more then what there intended for...the way brian makes them the possibilities are endless...