Newman Roller Master not making a flat screen.

[Mark @ Hurricane Printing]

Just got off the phone with Mr. George from Stretch Devices....gave me a lot of good info. For one, the frame corner that sets on the table without the clamps is correct by not setting 100% on a leveling pad...still doesnt make sense to me but that is how its supposed to be.

The 2 things I need to do is open the main valve up all the way until I feel resistance then turn in in a quarter turn...I DID originally open the valve up all the way but NOT till I felt resistance..I just opened it up what I felt was a lot and left it at that.

Also bring my torque wrench from 55 ftlbs to 60 ftlbs.

I will address this all tonight after work.

[gtmfg]

Sounds like you are were in the same situation I was in a couple of months ago. Like I said earlier, air pressure fixed everything.