"He who marches out of step hears another drum." ~ Ken Kesey
Just to follow up on this tread...I just installed a Newman panel N300 mesh 23 x 31 for M3 into an MZX frame.I ran into the same issue as the pictures that were posted with the mesh not reaching end to end. In order for the panel to be put in place I had to turn the rollers inward so that the channels were facing directly into the center of the frame. I normally start with the rollers in a similar position as in the pictures posted earlier in the thread.I was then able to get the mesh in place and stretched it to a quick 32 newtons. I am not sure how far the roller will be turned when they are at a work hardened state, but as of right now it is not a lot.I will post again when re stretched with details of my findings.
