Plastisol on top of dc base question

[blue moon]

-we have one head that's out about 5-6/1000th of an inch. If we don't add a little bit of trap, white will show every now and then. (yes, the infamous registration block MHM issue!)

If it was the blocks you would have issues with a certain pallet(s) rather than a certain head. And it would almost never be just one.

I meant platen, thanx for catching that. there are two more that are out 2-3/1000th of an inch, but that is really not visible on most prints.

pierre

[ebscreen]

Got it, just wanted to make sure you weren't chasing ghosts.

[chubsetc]

Are you guys running your shirts with the dc base through the dryer the same speed as straight discharge or are you speeding it up a bit, running my discharge at 360 degrees for 2 minutes currently.

[blue moon]

Are you guys running your shirts with the dc base through the dryer the same speed as straight discharge or are you speeding it up a bit, running my discharge at 360 degrees for 2 minutes currently.

we are slowing down the belt, but keeping the temp the same.

pierre