Looking for fix for bleed problem

[XG Print]

I think I am shooting in the dark here and I am probably going to have to replace it but one of my new guys went crazy with the spot gun on a poly hoodie that had red with the white color blocked sides.  Needless to say some of the red blead into the white in about an inch wide area.  Any fix or just get another??

[Ross_S]

Just get another one cause your not going to fix it and it's not worth the headache in trying

[Doug B]

  Limited success by taping off the red with masking tape and dab white on the
needed area. feather it out with your finger and run it through the dryer. It just
depends on the design as to whether this will work in this case. Just don't spend
a lot of time on it. It is worth a shot before you re-order a shirt.