About to print my first sim process...

[mimosatexas]

looks great!  Off topic, but I started using 25 instead of 22.5 and have seen an improvement with the S-mesh for some reason.  I was getting slight square moire issues with 22.5 that went away.  Anyone else seen something like this or know why this might be.  I'll admit I understand the basic reasoning behind the common angles chosen and how they relate to mesh interference, but not why 2.5 degrees would eliminate moire that shouldn't be there with 22.5 to begin with.

[3Deep]

Yep I had to chance my angle on some white plates

darryl

[Gilligan]

looks great!  Off topic, but I started using 25 instead of 22.5 and have seen an improvement with the S-mesh for some reason.  I was getting slight square moire issues with 22.5 that went away.  Anyone else seen something like this or know why this might be.  I'll admit I understand the basic reasoning behind the common angles chosen and how they relate to mesh interference, but not why 2.5 degrees would eliminate moire that shouldn't be there with 22.5 to begin with.

Murikami has a pretty badass chart of all the mesh counts and what works best for them.

[Doug S]

looks great!  Off topic, but I started using 25 instead of 22.5 and have seen an improvement with the S-mesh for some reason.  I was getting slight square moire issues with 22.5 that went away.  Anyone else seen something like this or know why this might be.  I'll admit I understand the basic reasoning behind the common angles chosen and how they relate to mesh interference, but not why 2.5 degrees would eliminate moire that shouldn't be there with 22.5 to begin with.

I just started using a 25 angle due to a recommendation for s mesh and noticed a difference right away.