Author Topic: Neck prints on Diamondback S  (Read 1165 times)

Offline Rockers

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2073
Neck prints on Diamondback S
« on: March 31, 2014, 09:58:20 PM »
just wondering what you guys who own a Diamondback S do in order to prevent the squeegee running of the pallet. If I remember right I read a few times that it`s really not so recommended to have it run over the edge of your pallet. Well now we have almost 200o tees coming up, all discharge neck print with the image being placed around 1.5 inches below the neck. Adjusting the floodbar angle of course is one option but that won`t leave us with much space for ink I guess. Just wondering if I approach this all the wrong way and maybe there is a very simple solution.


Offline broadway

  • !!!
  • Full Member
  • ***
  • Posts: 204
Re: Neck prints on Diamondback S
« Reply #1 on: April 01, 2014, 08:10:07 AM »
I have only had my Dback S since January. Squeegee's belong on the platen not over. If plattens are set up correctly you should be able to just move the shirt down or you could move your screen up with the side clamps. I have yet  to move/replace  my platens. I will leave the plattens right where the tech left them. The squeegee does land about a half inch from the edge,on the platen. With such a high neck print i like to have the sewn label hang over the edge. That way it is away from the image area. Even an inside transfer label might get in the way with discharge ink. I just did some gildan poly shirts and label was huge on the inside.

Offline dirkdiggler

  • Gonzo Member
  • ******
  • Posts: 1803
Re: Neck prints on Diamondback S
« Reply #2 on: April 01, 2014, 08:21:09 AM »
move your art up on the carrier, now your new problem is it wont flood all the way, if its plastisol its not a big deal, but with discharge its gonna be a problem.  No way around it on the DB.
If he gets up, we'll all get up, IT'LL BE ANARCHY!-John Bender

Offline brandon

  • Gonzo Member
  • ******
  • Posts: 1709
Re: Neck prints on Diamondback S
« Reply #3 on: April 01, 2014, 10:28:01 AM »
Regarding it being a water base print if you use an open mesh and keep the press moving and depending on the design it is not law to flood or fill the screen. You can get away with it being set for plastisol. Just keep an eye on it.

Offline Rockers

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2073
Re: Neck prints on Diamondback S
« Reply #4 on: April 01, 2014, 06:27:37 PM »
Hm I`ve considered making an longer stop block.
« Last Edit: April 01, 2014, 11:48:46 PM by Rockers »

Offline jsheridan

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2130
Re: Neck prints on Diamondback S
« Reply #5 on: April 02, 2014, 08:05:05 AM »
Hm I`ve considered making an longer stop block.

stop overthinking and just print.

Blacktop Graphics Screenprinting and Consulting Services