Author Topic: Pin Stripe  (Read 1384 times)

Offline mpot

  • Verified/Junior
  • **
  • Posts: 79
Pin Stripe
« on: August 24, 2013, 08:40:00 PM »
I have a customer that wants to print old school pin striping behind and around a logo.
This will be red on a black shirt. The pin stripes are only 3 pt. wide.
Would you underbase these? If I choke them back there isn't any line left to print. If I leave them full width I have problems with registration.

What are your thoughts?

Matt


Offline Nick Bane

  • Full Member
  • ***
  • Posts: 236
Re: Pin Stripe
« Reply #1 on: August 24, 2013, 08:50:54 PM »
i printed some pinstripes not long ago, and not that thin, but if i were doing it again, id use discharge ink just like the first time since they came out so nice.   8)
Bane Ink - 619-701-4283

Offline Frog

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 13980
  • Docendo discimus
Re: Pin Stripe
« Reply #2 on: August 24, 2013, 08:52:04 PM »
Assuming plastisol ink,
If all of the red is small like that, you may do fine with just a good opaque ink.
On the other hand, if the rest of the design justifies it, an underbase line of 2pts should still add some pop, and be fairly easy to register on most presses.
That rug really tied the room together, did it not?

Offline Gilligan

  • !!!
  • Ludicrous Speed Member
  • *******
  • Posts: 6853
Re: Pin Stripe
« Reply #3 on: August 24, 2013, 08:57:21 PM »
Make the top color larger and keep the under base at 3pt.

Offline mpot

  • Verified/Junior
  • **
  • Posts: 79
Pin Stripe
« Reply #4 on: August 25, 2013, 07:26:36 PM »
I actually have some discharge samples that I was beginning to work with but am inexperienced to print for a customer. Chicken I guess! I have to start somewhere so I'm going to try it tomorrow. Thanks for the push.
Matt

Offline Inkworks

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1761
  • Pad&Screenprinter
Re: Pin Stripe
« Reply #5 on: August 25, 2013, 07:31:22 PM »
Don't be afraid to load up a bit on the pigment for the red. The recipe my mixing system called for needed boosting by almost 400% to get a decent red.
Wishin' I was Fishin'

Offline mpot

  • Verified/Junior
  • **
  • Posts: 79
Pin Stripe
« Reply #6 on: September 03, 2013, 08:32:17 PM »
Ok so I did this with Magna white and also mixed up some Magna red. The discharge was easy to do!! I'm sold!

Offline Inkworks

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1761
  • Pad&Screenprinter
Re: Pin Stripe
« Reply #7 on: September 03, 2013, 09:04:53 PM »
Nice tone fade on that one, those can be tough to hold when using enough pressure to drive DC into the shirt.
Wishin' I was Fishin'