Ok whats going on here... Hopkins BWM

[Prosperi-Tees]

My carousel started getting tough to spin so I checked to see if it was level to the floor and it was way off. I leveled the feet and now it is making a popping noise when I spin the table and this little bad boy is popping in and out causing the noise. I tried going back to unlevel and it is still popping and it does it either spinning left or right.

[tpitman]

What the hell is that (The video's owner prevents external embedding)

[Baron265]

It may be that is the locating assembly for the pallet carousel. If you remove the end cap by unthreading it, you'll probably find a compression spring. In front of that will be the piece that the spring pushes into the locating features on the center shaft. I say, remove the end cap and spring and look inside.

[tonypep]

Agreed. On original Hopkins this is adjustable

[Binkspot]

Like said above but you need to add grease to the plunger when it goes back together then adjust it so you feel the detent when when rotating