We are printing a 2 color print (red&black) on a white tultex blend tee. The Test print went fine, but when we switched to the real garments, and it seemed like the black ink was bleeding out.
We are using a 230 mesh, at 28n, and we were using black ink straight out of our union mixopaque bucket.
The ink wasn't to thin, there was normal pressure being applied, correct angles, but for some reason, the ink would look a little fuzzy before going through the dryer, then at the end of the dryer it would look like the oil was escaping from the plastisol, and forming a little ghost haze around the image.
I've since switched to waterbased black and that fixed the problem, but what were we doing wrong? or doing to make it cause that? My dryer was at normal speed, and i lowered the temp. from 330 to 310.
any ideas?