« previous next »
Pages: [1]   Go Down

Author Topic: Clevis pin (I think)  (Read 1614 times)

Offline Sbrem

  • Ludicrous Speed Member
  • *******
  • Posts: 6055
Clevis pin (I think)
« on: June 21, 2021, 08:28:11 AM »
This pin broke on our trusty old Insta 226 heat press. My measurements have it at 1/2" diameter by 5/8" overall length, and the outer edges and grooves are 1/16", etc. I've tried McMaster Carr and Grainger, but in the 1/2" dia. only come in longer, 1" and up lengths, which won't do. So I'm looking for suggestions for a vendor, thanks in advance.

Steve
Logged
I made a mistake once; I thought I was wrong about something; I wasn't

Offline inkman996

  • !!!
  • Gonzo Member
  • ******
  • Posts: 3760
Re: Clevis pin (I think)
« Reply #1 on: June 21, 2021, 08:37:12 AM »
Take it to a local machine shop. Should not cost much to make, would only take them a few minutes
Logged
"No man is an island"

Offline mooseman

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2215
Re: Clevis pin (I think)
« Reply #2 on: June 21, 2021, 08:55:38 AM »
Logged
DUE TO CIRCUMSTANCES COMPLETELY WITHIN MY CONTROL YOU SHOULD GET YOUR OWN TEE SHIRT AND A SHARPIE MARKER BY NOON TOMORROW OR SIMPLY CALL SOMEONE WHO GIVES A SHIRT.

Offline Sbrem

  • Ludicrous Speed Member
  • *******
  • Posts: 6055
Re: Clevis pin (I think)
« Reply #3 on: June 22, 2021, 11:31:24 AM »
I spoke with McMaster Carr, and got a couple of 1" long, and will add some washers to take up the slack. Thanks for the recommendations.

Steve
Logged
I made a mistake once; I thought I was wrong about something; I wasn't
Pages: [1]   Go Up
« previous next »