Stuck in Teach Mode on Gauntlet lll.

[Dottonedan]

I’m working late and on the Gauntlet lll.

We have an alarm on head 18 that says it’s in teach mode.  Anyone know how to get out of that? I haven’t found it yet. Id look in the manual, but it’s at another location at the moment.

Thoughts?

[LuckyFlyinROUSH]

Make sure head sees rear sensor, flip breaker off and on?

Never heard that one.

[Dottonedan]

Thanks for jumping on.  We will give that a shot.  If s not preventing  from printing but scares us of course.

[Dottonedan]

Got the answer.

Ok.  We found out what it is. It happens by accident or goes into this mode  (if), you happen to have a pallet collision with something (like we did last night). We were Tri-Locking and indexed to the next pallet but the Tri-Loc and pallet didn’t drop all the way.  Not sure why it didn’t drop fully. Like the Tri-Loc stuck a bit. It had a lip of about 1/16” (I happened to be right there watching the Tri loc process and once he rotated the pallet to do the next one, I still stayed in place (raised up a bit) and it snapped away from the frame and knocked the end contact point off of our Tri-Loc.

So keep a good eye on it when Tri-Locking and indexing. Make sure it’s clear first and the pallet fully drops.

[Jwcontractscreen]

On a Gauntlet III, the pallet better never drop or you’re going to have a really bad day:)

[Dottonedan]

Verbiage error.   Raise.  Frames raise.