Author Topic: How are you testing halftone detail?  (Read 1480 times)

Offline shirtshack

  • Verified/Junior
  • **
  • Posts: 34
How are you testing halftone detail?
« on: January 08, 2016, 09:03:30 AM »
On another post you will see I am testing EOM, but reading the forums I hear a lot of talk about resolution of half tone dot ect- Once I have finished with the EOM and tension I would like to try these tests to make sure my emulsion selection is good enough.

How would I go about testing this?
I use a epson 4800 with blackmax inks and Accurip software for my positives so I assume I need a good test file I can print, any body know where I can download one?


Offline jvanick

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2477
Re: How are you testing halftone detail?
« Reply #1 on: January 08, 2016, 10:06:00 AM »
I use a file that dottonedan created...

but this one works really nicely as well:

http://www.theshirtboard.com/index.php/topic,8018.0.html

to do this the 'right' way you may want a densitometer, however, you can certainly test with a file such as the above and eyeball until you get something that looks right from the 3%-95% range.  (if you can get a nice smooth transition through that range, you're doing better than most shops).


Offline Underbase37

  • Hero Member
  • *****
  • Posts: 790
Re: How are you testing halftone detail?
« Reply #2 on: January 08, 2016, 10:06:57 AM »
I would start here.

http://www.kiwo.com/expo-check/

You want to find the best exposure time that works with your emulsion and exposure unit.

One you get that dialed in, if you want you can make a small bar at the bottom of each logo you burn that has a halftone going from %0-%100 or %5-%95.

Sent from my XT1585 using Tapatalk

Offline shirtshack

  • Verified/Junior
  • **
  • Posts: 34
Re: How are you testing halftone detail?
« Reply #3 on: January 08, 2016, 12:08:57 PM »
I have an Amex Exposure calculator which appears similar to the KIWO, also have a strip that should expose and wash out to the 7 mark so I should be accurate with my exposure.

Offline jvanick

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2477
Re: How are you testing halftone detail?
« Reply #4 on: January 08, 2016, 12:10:53 PM »
once your exposure times are dialed, then I like messing with the rip, dotgain settings, coating techniques and washout techniques to get the best screens possible.