TSB

screen printing => Equipment => Topic started by: Dottonedan on October 18, 2018, 09:25:30 AM

Title: I-Image off centered from screen? Here is a tip.
Post by: Dottonedan on October 18, 2018, 09:25:30 AM

I’ve noticed even while working there, that the prints going on the screen are off centered by 3/16”

When you print and measure inside the pusher frame, it’s dead center of pusher. I am no engineer, but I gather that the difference is a result of the 3/16” tri-loc nubs added to the outside of the frame area on the right of machine.

For those looking for dead center, in Color Print folder setups,  just put in -.19 offset.   It won’t do exactly .1875 so it rounds off.

This is especially important for pocket prints where you need to fit within.

Title: Re: I-Image off centered from screen? Here is a tip.
Post by: dirkdiggler on October 22, 2018, 08:08:07 PM

YES!!! I need this so bad for pockets!!!!!  Thanks!

Title: Re: I-Image off centered from screen? Here is a tip.
Post by: Yogi8 on March 07, 2019, 01:38:35 PM

We are having the same problem with the image not being in the center of the screen.  We have an i-mage STE that we have had for about a year.  We also have the tri-loc system for our m&r auto press.  What have been people's solutions?  My press operators are tired of having to adjust all the time.
thanks for any info you may have.

Title: Re: I-Image off centered from screen? Here is a tip.
Post by: ericheartsu on March 07, 2019, 02:17:56 PM

do the newer systems have nubs, and not blocks?