TSB
screen printing => General Screen Printing => Topic started by: 2020 Print on September 05, 2017, 03:13:18 PM
-
Afternoon all,
Just had a customer send a picture of T-shirt we had printed for them where the logo has washed off. Am I correct in assuming this was under cured?
Let me know your thoughts on this!
Thanks again,
Matt
-
Under cured would be the correct answer
-
How do you monitor your cure temps 2020?
-
Are dryer and flash units have the temperature displays, additionally, we have a temp gun to make sure are dryer and flash units are showing the correct temperature.
-
Are dryer and flash units have the temperature displays, additionally, we have a temp gun to make sure are dryer and flash units are showing the correct temperature.
When I use a temp gun (non-contact thermometer), to check cures from 280-310, depending on garment and ink, it reads from 370 to sometimes almost 400 for a split second just before exiting.
-
Non-contact temperature guns only read the surface temperature. If you're "shooting" it and only reading 350 or less, you can be certain you aren't getting a complete cure. Someone a while ago posted the hiarchy of cure testing tools from paper thermometers to donut probes, but in many cases a good old fashion stretch test on the first couple test prints will give you a confident idea of whether you're curing or not.
-
Also just to add , it makes a difference if you have gas or electric. I've seen some electric dryers that need to be set at a much higher temp then a gas dryer . They're two different methods of curing a shirt. Also check your belt speed ,it's probably to fast .But like someone else said the stretch test is the best way to make sure it's cured .
-
Or a crock meter
-
Or a crock meter
With plastisol?
-
Nice to have around..........do the ole crock and stretch test ;)
-
Hi 2020, looks under cured to me, but there are a lot of possible causes to get this problem,a tip is you should check your dryer temp before you run your production, just print a rag with your design and trow it to the dryer, the stretch test is a good indicator, sometimes we start the dryer and we believe it has reached the right temp, but reality its not.