TSB
screen printing => Newbie => Topic started by: sbrown on March 18, 2017, 02:31:48 PM
-
Frog - What "foam thickness" would you recommend for the compression jig?? Would 2" be slightly not tall enough you think? I was guessing 3", but not sure.
-
It would depend on the denseness of the foam, but probably at least half again as much as the depth of your screens.
The more pressure, the more contact, but of course, if you went crazy with it's thickness, you'd break the glass.
-
Thanks, I went with 2" since in person 3" was definitely going to be way too thick.
-
Do yourself a favor. Get a spray bottle and wet your screens after exp them it looks like your washout boot is close to the outside. as soon as there exposed.
I would go and find a old ice box and trun it into my screen storage and white ink storage.
and you could put a few beers and ice for after work. it will give the kids a space for their drawings for daddy
Howard Ray 713 344 8604 howards services....Ex workhorse/tuf products tech 26 yrs
-
Frog -
Is there a previous thread describing the details of how to build that compression jig that you shared a picture of a while back???... Id like to build one, but just going off the picture is a little vague. It seems simple enough but would beneficial to have a little more detailed information.
Best
Shaun
-
Frog -
Is there a previous thread describing the details of how to build that compression jig that you shared a picture of a while back???... Id like to build one, but just going off the picture is a little vague. It seems simple enough but would beneficial to have a little more detailed information.
Best
Shaun
Nope, back when I made that pic many years back, it just stood by itself as the foundation of a DIY project, obviously requiring some basic woodworking skills.
Do you have any idea at all how to get going?
Can you figure out a way to make a wooden frame that secures the piece of glass? That may be the most important part because it has to handle the stress.