TSB
screen printing => Equipment => DIY - From master engineered marvels to cobbled together jury-rigged or Jerry-built junk! => Topic started by: steve1coelho on February 19, 2015, 09:39:42 AM
-
This is my registration board. I put 4 corners on here so when you set the screen in there is no movement.
-
Nice DIY.. is it working as you expected... I think you may be slightly better off with a 3 point system vs 4 point if all corners of your creen frame are not square it may through the reg of tick from screen to screen.
-
This is what I use, second generation, third is in the works. Works fine just want it to look better. Yes it is Bri-Loc compatible.
-
I have not used it yet still trying to get set up. I was looking to see what the thoughts were on this im sure someone has tried this before. I figured since I would be using newman exclusively that I would always have a square level screen. The three point do you use that on press as well?