TSB

screen printing => Screen Making => Topic started by: papinc on September 04, 2014, 05:01:26 PM

Title: M&R Tri-Loc Master Frame Push Pins
Post by: papinc on September 04, 2014, 05:01:26 PM

I have push pin that's been intermittently sticking...and it's becoming more of a regular occurrence. I've tried some WD-40 to lubricate, but the results are lacking at best. Any suggestions on another lubricant that would fix this problem...or other suggestion?

Thanks

Keith

Title: Re: M&R Tri-Loc Master Frame Push Pins
Post by: 244 on September 04, 2014, 05:25:56 PM

Quote from: papinc on September 04, 2014, 05:01:26 PM

I have push pin that's been intermittently sticking...and it's becoming more of a regular occurrence. I've tried some WD-40 to lubricate, but the results are lacking at best. Any suggestions on another lubricant that would fix this problem...or other suggestion?

Thanks

Keith

Pull the retainer clip on the back of the pin. Remove assembly and clean with a fine grit sandpaper. Must have a bur or contaminate as we don't lubricate. Should be self lubricating plastic.

Title: Re: M&R Tri-Loc Master Frame Push Pins
Post by: papinc on September 04, 2014, 05:49:20 PM

Thank you Rich! I'll give that a shot.