TSB
Classified Ads => Wanted => Topic started by: blue moon on April 24, 2014, 02:13:39 PM
-
'just bought some frames and need the pins for them. There are at least two different versions of the pins and we need the ones with narrower body (1 1/8th wide opening).
pierre
-
We bought ours directly from Newman if I remember correctly...
Steve
-
You back already?
-
How many sets do you need?
-
How many sets do you need?
16 sets to start with, but will take anything.
I have some of the wider ones if you can use those!
pierre
-
We bought ours directly from Newman if I remember correctly...
Steve
any idea on the price?
pierre
-
You back already?
came back this morning!
pierre
-
Can you post a pic of the type your are looking for? We have three different styles, only one of which I don't like, though
all function exactly the same.
-
Can you post a pic of the type your are looking for? We have three different styles, only one of which I don't like, though
all function exactly the same.
unfortunately, I don't have anything that will fit in the frames we just bought.
Here's what we do have (on a sample new MZX) and it's too wide by about a 1/8th of an inch on the used screens.
pierre
-
We bought ours directly from Newman if I remember correctly...
Steve
any idea on the price?
pierre
$40 per set, I'm pretty sure. I see you know there are different ones for the different frames... they also make your frames off center, so watch that, but I'm pretty sure you'll catch that, it's pretty obvious
Steve
Steve
-
We actually have 4 types, just found one I've never seen. Pic attached.
I'm spacing on what measurement is critical to you.
-
Here's what we do have (on a sample new MZX) and it's too wide by about a 1/8th of an inch on the used screens.
pierre
An angle grinder will make quick work of that for you. For the price of the pins new, you're best off making these fit your frames.
-
Pierre,
I have a box of these...a couple of different styles. (Didn't count them...but there are quite a few).(http://)
Would they be of any use?
Let me know.
Keith
-
Pierre,
I have a box of these...a couple of different styles. (Didn't count them...but there are quite a few).(http://)
Would they be of any use?
Let me know.
Keith
I am pretty sure that the one on the right is what we need! Sending PM!
thanx,
pierre
-
We actually have 4 types, just found one I've never seen. Pic attached.
I'm spacing on what measurement is critical to you.
I am just measuring the bottom width. Do you have extras? I would imagine you'd be using them!
pierre
-
Am I reading this thread correctly? A set of those pins new fetches $40?
-
I would think a local place could machine those in bulk for a hell of a lot less than $40 a pop....
-
When I showed them to my machinist brother-in-law and he said to buy them from the manufacturer, and before the jokes start, my in-laws and I are tight. They actually cost more than the used frames I put them on.
Steve