screen printing > Tips and Tricks to Share (Please don't ask questions here)

Dip Tank Screen Hold Down

<< < (2/3) > >>

repogolfer:
We drilled a small hole on each side of the plastic tank towards the top and used an old wire handle from a gallon ink container.  Ran the wire through the hole and bent ends.  It holds down the front corners of the statics nice and still puts it under the solution..then when you take it out all you do is move the wire towards you and it allows just enough room for the screen to pop up like normal....its always there and it works like a charm.

Jon

ol man:
use newmans

screenprintguy:
We just use a five gal chem jug with a gal of water in it, lay it o mmmmm top see inks them to the bottom  :o

sqslabs:
Used this setup for my dip tank and it works great.  Was fun to make, too.  Thanks for the post, kingscreen.

3Deep:
Ok I never used a dip tank but you would think they would make something better to hold your screens down for the money you guys paid for that plastic tub, so that you wouldn't have to build anything. Nice idea though.

darryl

Navigation

[0] Message Index

[#] Next page

[*] Previous page