Author Topic: matsui 301 RC Black  (Read 1162 times)

Offline nobrainsd

  • Full Member
  • ***
  • Posts: 127
matsui 301 RC Black
« on: February 14, 2013, 11:57:06 AM »
I have been having better results when I thin my Magna DC inks with a little water. I'm going to try out using Matsui 301 RC black today rather than mixing a black. While I can test the ink straight and mixed with some water I thought I would ask what others are doing when they print with the 301 Black.

Manual press, 230 mesh screens, eight color design indexed at 185 ppi, wow


Offline IntegrityShirts

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1179
Re: matsui 301 RC Black
« Reply #1 on: February 14, 2013, 01:33:15 PM »
straight out of the bucket or add a touch of fixer-n and print on the auto.

Offline Hegemone

  • Verified/Junior
  • **
  • Posts: 72
matsui 301 RC Black
« Reply #2 on: February 14, 2013, 08:37:17 PM »
I like it with a touch of curable reducer but it's not critical. I like the consistency of the black straight out of the bucket over some of the other rc colors.
(mikel@)(www.) 1PartArt1PartTee.com

Offline nobrainsd

  • Full Member
  • ***
  • Posts: 127
Re: matsui 301 RC Black
« Reply #3 on: February 17, 2013, 12:59:10 PM »
Here are a few prints from my first print run with the matsui black.  The matsui 301 Black is a very nice addition to my screen printing arsenal. Thank you for the replies and guidance. I did use it straight from the can. It didn't need any thinning for sure. Really nice deep black!

matsui 301 RC Black
PMS 426 Magna ULF DC mix
PMS 5757 Magna ULF DC mix
PMS 180 Magna ULF DC mix
PMS 616 Magna ULF DC mic
PMS 600 Magna ULF DC Mix
Magna Super White ULF DC
PMS 102 Magna ULF DC mix

Lost a little white opacity by printing second to last, but printing the yellow last made it pop and kept it from being swallowed up by the red.

printed 16" on back and scaled down on front
indexed seps at 185 ppi on 230 mesh

Gildan 2000 charcoal 
Independent Trading Co. IND 4000 fleece gunmetal heather

Inks ran very well. Toward the end of my 50 piece run I had some issues with the ink clearing the screens. Cleaned off the build up, thinned the ink a little and still had a hard time. I guess the 400+ passes with the 17" squeegee driving the wb into the substrate on my manual just plain wore me down! Either I'm getting old, don't print enough anymore, need an automatic or should start printing smaller images with lower color counts (no f'n way!).

Did I say how much I like my Magna ULF DC inks? :) Combined with the matsui black I have relatively bright lights and  great dark colors in an almost no hand print that makes me smile and keeps my neighbors happy too. Thank you to everyone who has helped me make the plunge into WB and DC!



« Last Edit: February 17, 2013, 01:08:13 PM by nobrainsd »