Author Topic: driving me crazy  (Read 2242 times)

Offline terryei

  • !!!
  • Full Member
  • ***
  • Posts: 214
driving me crazy
« on: June 15, 2011, 07:35:21 PM »
I use CorelDraw x3
attached is a logo I'm trying to re-do.
how do you get the s and the c to intertwine? Sometimes the c is in front, then another part is behind.
I've tried everything, and can't seem to figure this one out...
thanks
Terry


Offline Command-Z

  • !!!
  • Hero Member
  • *****
  • Posts: 956
Re: driving me crazy
« Reply #1 on: June 15, 2011, 08:46:53 PM »
Cut the S at the center of each curve. Cut exactly horizontally so the outlines match.  It will be 3 pieces. Then put the center piece behind the C.

Make sure the C has no outline, then copy it and make the outlined C be the very bottom piece.

Design, Illustration and Color Separation for the Imprinted Apparel Industry for over 20 years. SeibelStudio.com
 Custom art not in the budget? Check out Bad Bonz Designs

Offline terryei

  • !!!
  • Full Member
  • ***
  • Posts: 214
Re: driving me crazy
« Reply #2 on: June 15, 2011, 11:02:50 PM »
OK, how?
I know I'm being really stupid.
thanks

Offline Command-Z

  • !!!
  • Hero Member
  • *****
  • Posts: 956
Re: driving me crazy
« Reply #3 on: June 15, 2011, 11:37:22 PM »
Someone will have to correct me re: Corel, but there should be a Scissors tool or something like that to cut a line.
Design, Illustration and Color Separation for the Imprinted Apparel Industry for over 20 years. SeibelStudio.com
 Custom art not in the budget? Check out Bad Bonz Designs

Offline terryei

  • !!!
  • Full Member
  • ***
  • Posts: 214
Re: driving me crazy
« Reply #4 on: June 16, 2011, 12:57:03 AM »
Thanks Man,
There is a knife tool. Never used it before, worked great.
Thanks again.
Terry