screen printing > General Screen Printing

More newbie questions and why.

<< < (3/3)

Evo:

--- Quote from: Dottonedan on September 17, 2024, 09:32:48 AM ---Once you nail that down then...you can adjust the dot gain curves to provide a more open mid tone and pre-compensate on all prints.

--- End quote ---

To dig the rabbit hole deeper...

Curve adjustments should go hand in hand with specific inks used on press, squeegee speed, angle and pressure, etc etc. Tune and record all the variables that determine ink film thickness and dot gain on press, as these are the indirectly what you are trying to compensate for in the art department and screen room.

Adjust, observe, record, repeat.

Navigation

[0] Message Index

[*] Previous page