Checking screen tension out the box

[3Deep]

So when I buy new screens, I ask before I buy what tension they bring them up to, once I get them in, I pull them out the box check for flatness and then tension, so my question is, what method is the best or close to checking tension. Right now I do three points top, middle, bottom, I will say that most screens are close to what I was told.

[BP]

I always been told to do it in the middle of the screen, and checking long and short threads.

[Rockers]

So when I buy new screens, I ask before I buy what tension they bring them up to, once I get them in, I pull them out the box check for flatness and then tension, so my question is, what method is the best or close to checking tension. Right now I do three points top, middle, bottom, I will say that most screens are close to what I was told.

Interesting. We have a different approach when ordering screens. We tell them what tension we expect, depending on mesh count. So far they have not disappointed. We measure at 3 points, just like you do.  We did measure at 9 points but I figured that is pointless after a while as the screens we order are normally spot on.

[3Deep]

@Rockers, I use to ask for a certain tension, but decided I'd try what they normally do for other printers since I was having to many screens pop at high tension.