Tutorials/Training Video or Step by step process. > Art/Separation Tutes

My approach to a sim process left chest.

<< < (2/2)

Doug S:
That’s a really nice print.  What Lpi did you end up using?  For left crest sim process 65 lpi is about as high as I can go until I can squeeze more out of the rocket launcher.

Dottonedan:
On film, out of an Epson 1430, I did 70lpi.  Now, It’s a 600dpi printer so the quality of higher than 65lpi gets questionable. There can start to be some striations or what might look a little like banding at higher LPI from 70-85 even through people say you can do 85 on them.  You can, but it starts to lean in a negative way that high.  The only time I use higher is when I then compensate for this and open up the mid tones a little more. If I would normally take out 20% at 50% area making my 50,
 a 40, in this case,  I take the 50 down to to 35% or even 30.

Navigation

[0] Message Index

[*] Previous page