« previous next »
Pages: [1]   Go Down

Author Topic: Graphtec Blade Holder - Spring replacement  (Read 1172 times)

Offline Frog

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 13980
  • Docendo discimus
Graphtec Blade Holder - Spring replacement
« on: April 02, 2019, 09:29:04 AM »
What's the deal with the springs on these? Am I supposed to change the tiny spring each time I change the blade (seems logical), but I also seem to remember reading that the OEM blade holder doesn't allow it.
Given the price of a replacement holder (though aftermarket versions are way cheaper) I don't want to bung up the works.
Logged
That rug really tied the room together, did it not?

Offline Sbrem

  • Ludicrous Speed Member
  • *******
  • Posts: 6055
Re: Graphtec Blade Holder - Spring replacement
« Reply #1 on: April 02, 2019, 11:14:31 AM »
I've never replaced a spring in my Roland blade holder, though I think I bought a replacement holder along the way, it's 25 years old...

Steve
Logged
I made a mistake once; I thought I was wrong about something; I wasn't

Offline Frog

  • Administrator
  • Ludicrous Speed Member
  • *****
  • Posts: 13980
  • Docendo discimus
Re: Graphtec Blade Holder - Spring replacement
« Reply #2 on: April 02, 2019, 11:18:09 AM »
I have since spoken with someone at Clean Cut (where I get my blades) and he kinda' sorted it out.
Apparently, older holders had a spring that came out, while the newer ones don't. When one does not specify which, Clean Cut tosses one in with the order, just to be safe.
Logged
That rug really tied the room together, did it not?
Pages: [1]   Go Up
« previous next »