Failed transfers

[ericheartsu]

Eric, it sounds for me that you are over curing the transfer is dryer like you said. Also keep in mind that most transfer powders a made to put on wet ink. That is how I have done it for year with no problems.


FYI I really like the white stuff.
https://sourceone.nazdar.com/P/4575/White-Stuff-Heat-Transfer-Adhesive---Fine

This low melt powder polyester resin adhesive is used on heat transfer applications. White Stuff is applied to wet plastisol inks prior to the final cure. White Stuff locks the ink onto the substrate with a permanent, durable, and flexible bond.

Agreed. Most of the time we are adding in the hot melt powder (we use a poly urethane made one), however we've had really good results with the russell gray with the adhesion powder mixed in!

[mimosatexas]

I like the one stroke powder more than any other I've test so far, but I am always testing new ones too

[ericheartsu]

Gotta work on my registration, but i think i'm getting the hang of HSA transfers.

[Sbrem]

I like the one stroke powder more than any other I've test so far, but I am always testing new ones too

I just checked the One Stroke site, it appears they have 4 different powders. We aren't using One Stroke inks, which do you recommend for those? This is going to be for 100% cotton, and 50/50...

Steve

[Logowear]

Give Robert a call at One-Stroke Inks. 800-942-4447
He'll let you know which one is best for your application.