So we were instructed to spray lube on the brake/guide rather than using the grease port, which is probably fine, but that just seemed a little off considering it had a grease port so I hunted the oem lube down and ordered it in.
(fyi, the reason for ryonet recommending this was US users snapping off the smaller sized zerks, being used to the larger sized ones common in the US)
If anyone feels up to using the smaller zerks and wants a tube of the SKF LGMT grease for lubricating the brakes/guides of these machines email me your address and I'll send it out to you. moq was a case of this product and I would be concerned if I was still alive by the time we went through a case of this for a 100k cycle maint item so I'd rather hand some of it out for others to use. Your press probably came with the proper grease gun for this.
