Direct to Garment > DTG - General
which pretreat machine do you recommend?
downtowntshirts:
Looks like I am going to pull the trigger on the M Link X. Any recommendations on a good pretreat that won't break the bank?
Thanks,
Tom
Maxie:
I have a Kornit Paradigm, it's a printer that fits into a carousel.
We print the pre treatment onto the shirt, flash and then print digitally.
I'm sure you could do the same, use a fine mesh and print the primer, flash and then put it in the DTG.
mimosatexas:
from what I could find online the Schultz Pretreater is pretty much standard for anything not kornit.
The idea of screenprinting the pretreat is interesting, but the pretreat we use is as thin as water. It would fall right through any mesh count we have...
Shanarchy:
I also just ordered an M-Link X. We went with the M&R EZPrep, which I understand is the Schultze unit rebranded.
What are you going with for a heat press? We currently have an older Hotronix STX20, but it does not have hover mode. I'm weighing options for a new STX20, Fusion, Or Geo Knight.
mimosatexas:
our fusion is the most versatile, but i like the geoknight dk20 better overall. Just feels like a better built machine. We have one of each, and 2 hix swingman which i hate...
Navigation
[0] Message Index
[#] Next page
Go to full version