It's been a minute since I've had a decent sized multicolor sleeve job, but I have a 6 color sleeve print later this week and was looking for a little advice. In the past, I've ran into some trouble forcing smaller sleeves (primarily XS and S) over M&R style auto pallet brackets. I not only hate stretching the sleeve out, but more importantly, I've run into issues from the sleeve being stretched so tightly around the bracket it can occasionally slip when it hits the flashes causing reg issues. The only way I've found to mitigate this is sending the garments around the press once with the heads off allowing them to settle before printing, but I'm hoping there's a better way. Has anyone had similar experiences or have any thoughts?
Thanks in advance!
