21x28 triloc, manual equipment, little buddy dryer, etc.

[LoneWolf2]

Lots of equipment just sitting around that never gets used anymore now that i'm in my bigger shop.

Located in Dalton, GA

All prices obo

$2,800
21x28 triloc- comes with exposure jig/pin bar, registration pallet, and stop block. Also have a 23x31 exposure jig that can be thrown in for free as well.

$5ea if you buy the triloc as well.
~ 40 21x28 aluminum frames. Mix of 156 and 230 mesh. Most have tape/emulsion on still. (would make a killer deal on these if you take them all)


$1500
Black Body little buddy dryer.
240v model (single phase 12.5a)
Used for years with no issues. Wonderful little dryer for folks looking to upgrade from a standard flash, or smaller conveyor

$2,500
Riley Hopkins joystick - 6/4 , comes with youth wood pallets and brackets. Aluminum rubber top adult pallets. Will most likely need extra bolts/nuts for the 2 arms that are off as I lost them during the move. Can pick them up at your local hardware store for cheap.

Also have an older plastic washout booth and a flash I can throw in with the press and dryer if you want to take the whole bundle.


Shipping will be on buyer. Can palletize/crate it for additional $, or free to pickup.

[LoneWolf2]

Also have two almost-new hotronx auto cap heat presses. Used for one big job doing neck label transfers on sweatshirts.
$700ea + shipping. COmes in original box/shipping foam and all that good stuff.

[LoneWolf2]

One of the heat presses is now gone. Everything else is still ready to go.

[LoneWolf2]

bump

[LoneWolf2]

All still available.

[LoneWolf2]

$4k for the press, pallets, conveyor dryer, flash, screens, and washout booth. Need the space in the shop for new equipment.

[gotshirtz001]

Still have the 23x31 Tri-Loc master frame?

[LoneWolf2]

Nope, sold it a while back and forgot about this thread.

still have the full 21x28 setup.