Soft top pallet rubber

[travis.hoyme]

Does anyone know the best source for this material?


Sent from my iPhone using Tapatalk

[Biverson]

Action Engineering


Sent from my iPhone using Tapatalk

[RICK STEFANICK]

Action Engineering


Sent from my iPhone using Tapatalk

yes, and it has the adhesive back so no more of that high temp glue. I am sure m/r has it and Bill faust also. Check prices

[mooseman]

This stuff works pretty well for us

pallet rubber
https://www.mscdirect.com/product/details/31934672

vacuum blanket rubber
https://www.mscdirect.com/product/details/31939630
mooseman

[Stinkhorn Press]

my understanding is there is "good rubber" and everything else.
action and M&R (and the actual manufacturer) have good rubber.

if you've ever had to deal with less than good rubber, the prices M&R/action charge are cheap, reasonable, wonderful.

i've dealt with bad rubber. it's a nightmare. pay the man and move on.

[domineight]

What do you mean bad rubber?

Oddly, I once torched a pallet under the flash.  (actually ive probably done that almost a couple handfuls of times) but the replacement for whatever reason just never held tack like what I already had. Was the most annoying thing.

I could understand when it was new perhaps. But this went on for a long long time after. Quite annoying given the cost of it locally.

It was like that particular pallet leached a silicone nullifying spraytack. Even table tack on that pallet didnt last as long as the original pallets.

my understanding is there is "good rubber" and everything else.
action and M&R (and the actual manufacturer) have good rubber.

if you've ever had to deal with less than good rubber, the prices M&R/action charge are cheap, reasonable, wonderful.

i've dealt with bad rubber. it's a nightmare. pay the man and move on.

[Stinkhorn Press]

What do you mean bad rubber?

my understanding is there is "good rubber" and everything else.
action and M&R (and the actual manufacturer) have good rubber.

if you've ever had to deal with less than good rubber, the prices M&R/action charge are cheap, reasonable, wonderful.

i've dealt with bad rubber. it's a nightmare. pay the man and move on.

bad rubber - could probably have all sorts of different problems.
OUR bad rubber meant tape on it's surface was a nightmare - hard to remove without resorting to solvents and time and elbow grease - as it would tear as it peeled - took us forever to figure out it wasn't the TAPE that was the issue. Good tape on good rubber is only a tiny improvement over the cheapest, most wrong tape on good rubber. After 1000's of flashes and prints, if you can't grab your tape and peel it off in under 10 seconds in one clean sheet - your rubber is bad.