Workhorse Step-Back

[Logoman]

Anyone use the function Step-Back. We have used it a couple of times but not much.

[Nation03]

I was always curious if this mode is faster then a print flash print with the flashback.

[kingscreen]

We have used it only a few times.  It’s an incredibly slow mode.  Only benefit we found is that if you have a print color after your flash (we run Flashbacks) it flashes that color by default when it prints the second hit of the color before the flash (assumed White).

[Nation03]

Hey Scott,

Is it faster to print flash print with the flashback? Do you have any issues with burning the screen on s-thread mesh?

[kingscreen]

Hey Scott,

Is it faster to print flash print with the flashback? Do you have any issues with burning the screen on s-thread mesh?

Yes. And Orbital table up mode is faster than PFP with the Flashback. Somewhere I have notes on all of that. We run 99% of the time with our Flashbacks in table up mode.

We don’t have any issues with S-mesh.  But not all our screens are S-mesh.

[Nation03]

Awesome, thanks! I run my flashback on head 2 in table up mode and use it as a standalone flash right now. I'm on pace to upgrade to a Sabre in either 2018 or early 2019 depending on when we move to a new location.