Heat Seal - Heat Press - Whatever you want to call it! > General Heat Seal

reversable basketball jersey

(1/1)

rmonks:
Any trick to heat pressing vinyl numbers to both sides of reversable basketball jerseys.

aauusa:
just make sure you separate the layer when pressing.

t_fehrenbacher:
Hi There...  Great question by the way!!
You can, as rmonks mentioned - open your shirt up and put it on the bottom platen of your press (as if the press is wearing it) and press each side accordingly. OR you can use a Teflon Pillow inside the shirt to keep those layers from sticking together or being reheated. Teflon pillows come in a wide range of sizes.
Hope this helps :)

Binkspot:
You can go without the teflon sheet in between, just be sure to flip the shirt inside out right after you apply the heat otherwise they will stick together. We always use a teflon sheet over the numbers and covering any imprint. If you get the imprint with the heat press it will stick to the bottom of the heating element, possibly mess it up and it will transfer to the next thing you put in the press.  Follow the directions for the vinyl numbers too much pressure, heat or time they will get stiff, too little they will peal off and not necessarily now but  later down the road after they have been washed a few times.

Navigation

[0] Message Index