Vinyl and similar products applied without a heat press > Cold Vinyl

Just finished wrap

(1/2) > >>

Denis Kolar:
Just finished this project for a family friend.
Did the design (Logo and everything), printed in-house and installed on Saturday.
Came out pretty neat I think.

Homer:
Not to piss in your corn flakes, just an observation here, take it for what it's worth. Your seams are going the wrong way. they *should* be vertical panels starting from the back of the vehicle. If you do decide to panel horizontally, you want the overlap the other way, so it's on TOP of the bottom panel so it doesn't create a "shelf" for water to sit on. You may see this fail prematurely...just sayin...

Denis Kolar:

--- Quote from: Homer on October 10, 2016, 08:44:52 AM ---Not to piss in your corn flakes, just an observation here, take it for what it's worth. Your seams are going the wrong way. they *should* be vertical panels starting from the back of the vehicle. If you do decide to panel horizontally, you want the overlap the other way, so it's on TOP of the bottom panel so it doesn't create a "shelf" for water to sit on. You may see this fail prematurely...just sayin...

--- End quote ---

I know that. Customer just wanted to eliminate seems.
Put edge sealing tape (Half width) over the seem to prevent the "shelf"  :)

But thanks anyhow, good points to make someone aware of it.

blue moon:
looks nice!

pierre

3Deep:
Looks neat, I saw them wrapping a car at the SGIA looks like a lot of work!!!!

Navigation

[0] Message Index

[#] Next page