screen printing > Separations

How would you sep this?

(1/10) > >>

Prosperi-Tees:
Keep in mind I only have 158 and 230 mesh. The 230 mesh is kinda soft though, the 158s are tight.

screenxpress:
if you're asking based on mesh and 230 being tops, it could be done, but not as well as with 305.  Could be bad news if the 230 is soft though.

Was that the question?

Prosperi-Tees:
I guess the question would be what dpi on what mesh?

Screened Gear:
The perfect situation     LPI X 4.5 = Mesh you should use (or higher)

"To be safe" I would print the orange under the black on the print. Do the orange with 156 and the black at 45 LPI on your brand new tight 230 mesh screen.

If the client is ok with larger dots (most are not) you can do the same thing but do the black on a 158 at 35 LPI (I never go under 40 LPI and I have done them on 156 mess and even on 123 when I was in a bind. (have to know your emultion, exposure unit and times to make it work.)

Hope this helps.

Prosperi-Tees:
That does help, thanks

Navigation

[0] Message Index

[#] Next page