DIY screen stretching

[ffokazak]

What glue are you guys using?

[SI]

I have bought glue from multiple places.

Had good results with this brand.

http://www.spsi.biz/screen-printing-supplies/screens-frames/rhinotech-sma100

[abchung]

The most important for me is the roughness of the frame.

Then I would apply 5cm (2 inch) at a time. Making sure the glue penetrated the screen and there is no air bubbles.

[ScreenFoo]

Was going to post this a few weeks ago, sorry--if you are using Newman frames to re-stretch, bar clamps are sweet.

I put a manual frame down with the prepped side up, put the newman down with the mesh contacting it, put a bar clamp on each corner pulling the newman towards the static, and you can then adjust the preload on four corners.

Caveats:  Too much chem tape = not enough free mesh to glue a 23x31 to a 20x24. 
Table you glue on must be within a couple inches of one direction--i.e. either 30-32 inches wide, or 22-24 inches wide.