« previous next »
Pages: 1 2 3 [4]   Go Down

Author Topic: Squeegee/flood chopper topic  (Read 7515 times)

Offline GraphicDisorder

  • !!!
  • Ludicrous Speed Member
  • *******
  • Posts: 5872
  • Bottom Feeder
Re: Squeegee/flood chopper topic
« Reply #45 on: October 07, 2011, 12:28:21 PM »
Quote from: Inkman996 on October 07, 2011, 12:24:09 PM
Quote from: IntegrityShirts on October 07, 2011, 12:14:32 PM
Either the linear rail that the chopper plate rides on is installed at an angle, or the print arm itself is pitched where it attaches to the main body.  Which part is funky?

 I will check my parts package for one, oops I forgot I did not get a parts package lol.

Bait and switch son.
Logged
Brandt | Graphic Disorder | www.GraphicDisorder.com
@GraphicDisorder - Instagram | Facebook | Twitter | Youtube

Offline tonypep

  • Ludicrous Speed Member
  • *******
  • Posts: 5683
Re: Squeegee/flood chopper topic
« Reply #46 on: October 07, 2011, 01:19:08 PM »
On that blown seal that uneven pressure can definitely cause a seal to blow prematurely.
Logged

Offline JBLUE

  • !!!
  • Gonzo Member
  • ******
  • Posts: 2036
Re: Squeegee/flood chopper topic
« Reply #47 on: October 07, 2011, 01:50:08 PM »
This is great case for sure if that tube is in fact twisted. This is something that they should have noticed if they had assembled the machine over there. Im not knocking the guy that put it in but they should have never left that machine that way. It should have also been noticed during the install. That sucks!!!!!!!!
Logged
www.inkwerksspd.com

We are all born ignorant, but one must work hard to remain stupid...... Ben Franklin
Pages: 1 2 3 [4]   Go Up
« previous next »