Author Topic: Fusion dryer belt motor  (Read 991 times)

Offline whitewater

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1823
Fusion dryer belt motor
« on: October 21, 2015, 04:09:08 PM »
So this just happened. we were printing and the dryer was set at the speed of 4.5

all of a sudden the belt speeds up wicked fast and nothing can decrease the speed. I turned off dryer, and now its running really fast until it hits the 300 degrees..

What the hell would cause this?




Offline ebscreen

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4277
Re: Fusion dryer belt motor
« Reply #1 on: October 21, 2015, 04:16:11 PM »
Motor control. Likely a KBIC which seem to be failure prone.
Could be the speed control pot gone bust though, and I'd start there.

Offline ebscreen

  • !!!
  • Gonzo Member
  • ******
  • Posts: 4277
Re: Fusion dryer belt motor
« Reply #2 on: October 21, 2015, 04:21:15 PM »
Oh wait, Fusion is an M&R product. No idea what they use.

Offline whitewater

  • !!!
  • Gonzo Member
  • ******
  • Posts: 1823
Re: Fusion dryer belt motor
« Reply #3 on: October 21, 2015, 05:21:53 PM »
just overnighted a circuit board...