Anyone with a RayPaul Cureair Dryer out there?

[canucklehead]

We recently purchased a used RayPaul Cureair and it was shipped to us without the lower 5Hp recirc motor. I'm wondering if there's anyone out there that can pull a model/serial number off of theirs so's I can order a new one. I suppose the RPM and frame type would be handy numbers as well off the specs plate.

[GKitson]

M&R should be able to help you with this,

I believe they acquired Ray-Paul some years ago.

~Kitson

[244]

We recently purchased a used RayPaul Cureair and it was shipped to us without the lower 5Hp recirc motor. I'm wondering if there's anyone out there that can pull a model/serial number off of theirs so's I can order a new one. I suppose the RPM and frame type would be handy numbers as well off the specs plate.

its the same motor we use on our Sprints that use 5hp. Only need to know single or 3 phase

[canucklehead]

Oh, that's super!

this particular unit is 3 phase.

Model: 60121B8-81R
Serial: 37610793
3 phase/ 68.9 Amps

It was shipped without the mounting plate and pulley guard as well, but I think I can fab some stuff up at the shop. Any idea what size/type v-belt would go with that? 

[californiadreamin]

We recently purchased a used RayPaul Cureair and it was shipped to us without the lower 5Hp recirc motor. I'm wondering if there's anyone out there that can pull a model/serial number off of theirs so's I can order a new one. I suppose the RPM and frame type would be handy numbers as well off the specs plate.

Exact Replacement Is :   GE  5K184BD205A
                                     5 HP    184T Frame
                                     1725 RPM
                                     230/460 V
                                     3 Phase
Any motor that matches these specs will do.
I hope this helps.

winston

[canucklehead]

Thanks Winston. And thanks everyone!

[Zelko-4-EVA]

heres a pic of our cureair motor

i dont know the pulley diameters though...

[GKitson]

Another Ray Paul motor plate

[canucklehead]

Thanks again everyone. I wish I got on here earlier to sort this out. There's no shortage of knowledge and help in this forum. I hope I can give something back in the near future.

Cheers!