screen printing > DIY - From master engineered marvels to cobbled together jury-rigged or Jerry-built junk!
DIY Spot Cleaning Station
Binkspot:
The fluid evaporates before it even makes it to the shop vac. I have a similar setup and thought I could collect the used fluid and reuse it but there is never anything in there. Just don't use a flammable fluid.
tonypep:
We have some of these but accelerate the evaporation with an air gun @60 PSI
mooseman:
BRILLIANT!
mooseman
kingscreen:
No special filter. It's just a basic cheap wet/dry shop vac. As Binkspot said, the fluid evaporates before it even reaches the shop vac. Three 90-degree turns and a 36" vertical pipe almost guarantee it. Plus the height makes it comfortable to use while standing. Unfortunately, we had a situation that gave us the opportunity to test it out on about 80+ tees yesterday. >:( At the end, I pulled out the shop vac hose from the bottom and it was dry.
jvanick:
what non-flammable fluid are you guys using?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version