Computers and Software > Separation Programs
Epson 3000 Service manual link included. Topic: Removing the cover
mk162:
dan, what version of windows are you on? I got it to run on 7...i think.
you have to run & install it in compatibility mode
Sbrem:
--- Quote from: blue moon on December 08, 2014, 11:31:43 AM ---get some windex and soak a paper towel with it then park the heads on top of it. That should clear it . . .
pierre
--- End quote ---
We do that when we have to, plus we also have a large syringe we fill with cleaning fluid that fits over the nipples that the ink carts sit on, then squeeze the fluid through onto the aforementioned paper towel. When it starts to run clear, you're pretty close to clean... haven't tried it on a 3000, but it works on the 1400 and the like...
Steve
Dottonedan:
--- Quote from: mk162 on December 08, 2014, 03:02:44 PM ---dan, what version of windows are you on? I got it to run on 7...i think.
you have to run & install it in compatibility mode
--- End quote ---
Using windows 7. It's running, but I"ll need to fine tune it. Where or at what point to do you find the "compatibility" mode?
Frog:
--- Quote from: Dottonedan on December 08, 2014, 06:11:30 PM ---
--- Quote from: mk162 on December 08, 2014, 03:02:44 PM ---dan, what version of windows are you on? I got it to run on 7...i think.
you have to run & install it in compatibility mode
--- End quote ---
Using windows 7. It's running, but I"ll need to fine tune it. Where or at what point to do you find the "compatibility" mode?
--- End quote ---
I thought that that was an option offered up by Win 7 when installing a legacy driver
Dottonedan:
If so, I musta not needed it then, because I went to the Epson website and downloaded it's latest driver for my operating system and had no issues.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version